Exit Delay - eTIGER ES-K1A Manual Del Usuario

EN
Settings
Enter Setup mode
Press Arm [ ] or Home Mode [ ] on the keypad
to unlock it.
Type [admin code+#] to enter Setup mode.
Default admin code : 123456
Under setup mode, if no operation is made for 30 seconds the keypad will exit the setup mode
automatically. The setup mode can also be exited by pressing [*].

Exit delay

Detectors start detecting potential intrusions immediately after the system has been
armed. To prevent alarms when you leave your house, an exit delay can be set up. If
you have set up an exit delay, the control panel will receive the signal to arm the system
when you press the Arm key [ ] on the keypad after the time set.
1. Enter Setup mode.
2. Type [33+delay time in seconds+#].
3. You hear one beep: the setup is successful.
To deactivate the Exit delay, set 0 as delay time.
Remark
The time is set in seconds, it can be set from 0 to 255. Default setting: 0.
15