eTIGER ES-K1A Manual Del Usuario página 21

Problem
No response from
the control panel
when operating on
the keypad.
Cannot disarm the
system by RFID tag.
The keypad cannot
be set up.
The keypad cannot
arm, disarm or
switch to Home
Mode.
Cause
The keypad is not
registered in the control
panel.
The keypad is installed
too far from the control
panel.
The RFID tags have not
been registered in the
keypad.
The RFID reader is
disabled.
The keypad is locked.
The keypad is not
unlocked.
The keypad does not
switch to Setup mode.
Your user code or admin
code has not been typed
before each operation.
Solution
Register the keypad in the
control panel by following the
instructions in this manual.
Install the keypad and the
control panel closer to each
other.
It is recommended to buy
a repeater to extend the
transmission distance.
Register the RFID tag in the
control panel according to the
instructions in this manual.
Enter Setup mode and activate
the function "Enable / Disable
deactivation by RFID tag".
Press Arm or Home Mode, then
[*] before disarming.
Refer to instructions in this
manual.
Refer to instructions in this
manual.
Type your user code or admin
code before the operation.
EN
21