Content; General Warnings; Installation - Samoa 366760 Guía De Servicio Técnico Y Recambio

• Electronic digital meter featuring a turbine
measurement system, designed for precise
measuring of low viscosity fluids.
• Only use the unit for the purposes for
which it is intended.
• This unit has not been approved for use in
commercial transactions.
• Do not alter or modify the unit.
• Do not exceed the maximum unit working
pressure. See the technical specifications.
The meter can be connected to a control gun
or installed directly in the distribution line
pipe.
It is recommendable to install a cut-off valve
before the meter to facilitate its maintenance
or repair.
The meter has a 1"BSP connection at the
inlet and outlet (366760).
The supplied 1"BSP F-F bushing enables
several combinations of threads (366761).
The meter requires two 1.5 V batteries and
size AAA as the power supply source. See
"battery" section.
2
836 828 R. 10/12
Samoa Industrial, S.A. · Box 103 Alto Pumarín · 33211 Gijón - Asturias Spain · Tel.: +34 985 381 488 · Fax.: + 34 985 384 163

General warnings

• Use the unit with fluids and solutions
which are compatible with the moist parts
of the unit. See the relevant section of the
technical specifications.
• Observe the manufacturer's safety war-
nings for the fluids used.
you must avoid any contact between the
electrical power supply and the fluid
before any checks or maintenance work are
carried out

Installation

Main components:
1. LCD display
2. RESET key
3. CAL key
4. F-F bushing (366761)
NOTE: In order to improve the life of the
turbine, it is recommended to fit a strainer
before the meter itself.
ATTENTION
that needs to be filtered
,
disconnect the power source
1
2
3
.
.
4