Samoa 366760 Guía De Servicio Técnico Y Recambio página 5

Dispensing in normal mode
Normal mode is the standard dispensing.
While the count is made, the partial and
resettable total are displayed at the same
time (reset total).
WARNING
s
hould one of the keys be accidentally pressed
durinG dispensinG
A few seconds after dispensing has ended, on
the lower register, the display switches from
resettable total to general total: the word
reset above the word total disappears, and
the reset total is replaced by the general
total.
This situation is called standby and remains
stable until the user operates the meter
again.
Partial reset (normal mode)
The partial register can be reset by pressing
the reset key when the meter is in standby,
meaning when the display screen shows the
word "TOTAL".
Samoa Industrial, S.A. · Box 103 Alto Pumarín · 33211 Gijón - Asturias Spain · Tel.: +34 985 381 488 · Fax.: + 34 985 384 163
Operating mode
,
this will have no effect
Daily use
After pressing the reset key, during reset, the
display screen first of all shows all the lit-up
digits and then all the digits that are not lit up.
At the end of the process, a display page is
first of all shown with the reset partial and the
reset total
and, after a few moments, the reset total is
replaced by the non resettable Total.
Resetting the reset total
The reset total resetting operation can only
be performed after resetting the partial
register. The reset total can in fact be reset by
pressing the reset key at length while the
display screen shows reset total as on the
following display page:
5
R. 10/12 836 828