Samoa 366760 Guía De Servicio Técnico Y Recambio página 6

Schematically, the steps to be taken are:
1. Wait for the display to show normal
standby display page (with total only
displayed)
2. Press the reset key quickly.
3. The meter starts to reset the partial.
4. While the display page showing the reset
total is displayed.
Press the reset key again for at least 1
second.
5. The display screen again shows all the
segments of the display followed by all
the switched-off segments and finally
shows the display page where the reset
Reset Total is shown.
6
836 828 R. 10/12
Samoa Industrial, S.A. · Box 103 Alto Pumarín · 33211 Gijón - Asturias Spain · Tel.: +34 985 381 488 · Fax.: + 34 985 384 163
Operating mode
Daily use
Dispensing with flow rate mode display
It is possible to dispense fluids, displaying at
the same time:
1. The dispensed partial.
2. The Flow Rate in [Partial Unit / minute] as
shown on the following display page:
Procedure for entering this mode:
1. Wait for the Remote Display to go to
Standby, meaning the display screen
shows Total only.
2. Quickly press the CAL key.
3. Start dispensing.
The flow rate is updated every 0.7 seconds.
Consequently, the display could be relatively
unstable at lower flow rates. The higher the
flow rate, the more stable the displayed value.
ATTENTION: The flow rate is measured with
reference to the unit of measurement of the
Partial. For this reason, in case of the unit of
measurement of the Partial and Total being
different, as in the example shown below, it
should be remembered that the indicated flow
rate relates to the unit of measurement of the
partial. In the example shown, the flow rate is
expressed in Qts/min.