Changing The Slideway Lining; Working With The Electric Power Tool - Festool AH-ES-ETS/ETSC Manual De Instrucciones

English
6.3 Changing the abrasives
See figure [6].
6.4 Changing the base runner
► Removing the base runner [7a].
► Inserting the base runner [7b].
Use
– the enclosed LAS-H-ES base runner for
rough surfaces,
– the LAS-W-ES base runner with hook-
and-loop fastening and a velour
slideway lining for delicate surfaces.
6.5

Changing the slideway lining

See figure [8].
The GB-LAS-STF-ES/5 slideway lining can be
purchased as a consumable.
When sanding different materials, use a
separate slideway lining for each material
(e.g. one slideway lining for oiled surfaces
and another slideway lining for painted
surfaces). This avoids errors in the surface
coating.
7 Working with the electric
power tool
When working, never push down the power
tool so firmly that the sanding pad can no
longer rotate.
7.1 Base runner working position
See figure [9]
7.2 Working position for hands
When working, always hold the machine with
one hand on the power tool [10-1]. We recom­
mend placing the other hand on the handle
part [10-2] or over the base runner [10-3].
8 Accessories
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk.
9 Environment
Do not dispose of the device in the
household waste! Recycle devices,
accessories and packaging. Observe
applicable national regulations.
EU only: In accordance with the European
Directive on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
10
and handed in for environmentally friendly
recycling.
Information on REACH: www.festool.com/reach