Safety Warnings; Intended Use; Sanding Mode Setting; Setting The Sanding Angle - Festool AH-ES-ETS/ETSC Manual De Instrucciones

1 Symbols
Warning of general danger
Read the operating instructions and
safety instructions.
Do not dispose of it with domestic
waste.
Disconnecting the mains power cable
Tip or advice
Handling instruction
2

Safety warnings

WARNING! Read all safety warnings,
instructions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Observe the operating manual of the power
tool.
3

Intended use

The AH-ES-ETS/ETSC is intended for sanding
edges in connection with the ETS 125 REQ,
ETSC 125 Li power tools.
The AH-ES-ETS/ETSC must not be used in
conjunction with the ETS 125 EQ power tools or
any orbital sanders/delta sanders (DTS 400,
RTS 400, DTSC 400, RTSC 400).
Do not use the AH-ES-ETS/ETSC with the
ST-STF 125/8-M4-J SW sanding pad. The
larger size of the sanding pad can cause
the abrasive to collide with the base
runner.
4 Parts of the device
[1-1]

Sanding mode setting

[1-2] Handle
[1-3] Angle lock rotary knob
[1-4] Angle display
[1-5] Base runner button
[1-6]
Base runner
The specified illustrations appear at the begin­
ning of the Operating Instructions.
5 Assembly
5.1 AH-ES-ETS/ETSC Assembling on the
power tool [2]
► Insert the housing shell [2-2] into the
protector groove [2-3] of the power tool.
► Place the counterpart housing shell [2-1]
on top.
► Connect the housing shells with the two
enclosed screws and a hex key.
5.2 Calibrating the angle display [3]
The machine has an adjustable angle display.
After first assembling it on your power tool, the
angle display must be calibrated to your power
tool.
► Set the sanding mode to "Hard" (see
Section 6.1 ).
► Release the angle lock rotary knob [3-3].
► Use a measuring tool to set the angle to
90°.
► Tighten the angle lock rotary knob.
► Loosen the angle calibration locking
screw [3-1].
► Move the angle display [3-2] until the
display points to the 90° mark.
► Tighten the angle calibration locking screw.
6 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
6.1 Sanding mode setting
Hard mode [4a]
In Hard mode (setting for pre-sanding), the
edge is sanded according to the set angle.
Soft mode [4b]
In Soft mode (setting for intermediate sanding),
the AH-ES-ETS/ETSC adapts exactly to the
existing surface so that paint or filler is not
sanded through.
6.2

Setting the sanding angle

See figure [5].
English
9