For Best Results - Cooper Lighting RFM182 Instrucciones

RFM182_W 825-0255.qxd:Layout 1
method of electrically connecting the fixture to it must be in
accordance with the National Electrical Code and local building codes.
WARNING: Risk of fire. Supply conductors (power wires) connecting
this fixture must be rated minimum 90º C. If uncertain, consult
an electrician.
• For proper operation and protection against damage, the motion sensor head
adjustment knobs must be facing the ground.
• Disassembly of your fixture will void the warranty.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. Under Part 15 of the FCC Rules, any changes or
modifications to the motion detector described in this instruction sheet that are not
expressly approved by Cooper Lighting, LLC could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: FCC Regulations state that any unauthorized changes or
modifications to this equipment not expressly approved by the manu-
facturer could void the user's authorization to operate this equipment.

FOR BEST RESULTS

• Install the motion sensor 6-8 feet above ground (motion
sensor is less sensitive above 8 feet).
• Locate motion sensor so motion moves across detection
zone (Fig. 1).
• Locate sensor away from heat producing sources to
prevent false triggering. Also, be very careful not to include
objects such as windows, white walls and water in the
detection zone whenever possible.
• Locate sensor away from moving objects such as trees and street traffic.
Call for customer service and/or missing or damaged parts (800-334-6871)
11/13/08 10:09 AM Page 3
3
Fig. 1