Mode Of Operation - Cooper Lighting RFM182 Instrucciones

RFM182_W 825-0255.qxd:Layout 1
HOW TO SELECT YOUR DESIRED FEATURE
Mode of
operation:
Auto Setting
(motion activated)
Both fixtures will
automatically turn ON when
motion is detected by the motion
floodlight sensor, and will remain
ON for four or twelve minutes.
Dusk to Dawn Setting
Allows both fixtures to be turned
ON at night and remain ON until
the following dawn (can only be
activated at night). At dawn the
fixture will reset to auto setting.
Standard Flood
Setting
Allows both fixtures to be manu-
ally turned ON and used as a
standard floodlight (can only be
activated at night).
Test Setting
This mode is used for set up of
fixture during initial installation.
It allows remote light to turn on
both day and night and stay
ON for eight seconds.
TWO-YEAR LIMITED WARRANTY
Cooper Lighting, LLC ("the Company") warrants this product ("the product") against
defects in material or workmanship for a period of two years from date of original
purchase, and agrees to repair or, at the Company's option, replace a defective
product without charge for either replacement parts or labor during such time.
This does not include labor to remove or install fixtures.
This warranty is extended only to the original purchaser of the product. A purchasers
receipt or other proof of date of original purchase acceptable to the Company is
required before warranty performance shall be rendered.
This warranty only covers product failure due to defects in materials or workmanship
which occurs in normal use. It does not cover the bulb or failure of the product
caused by accident, misuse, abuse, lack of reasonable care, alteration, or faulty
installation, subjecting the product to any but the specified electrical service or any
other failure not resulting from defects in materials or workmanship.
There are no express warranties except as described above.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT
OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. ALL IMPLIED
WARRANTIES, IF ANY, INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY
Call for customer service and/or missing or damaged parts (800-334-6871)
11/13/08 10:09 AM Page 6
Motion Sensor
(Transmitter)
Set slide switch to:
4 MIN
or
12 MIN
Keep power ON to fixture
Set slide switch to:
4 MIN
or
12 MIN
Turn power OFF and ON
twice within 3 seconds
Set slide switch to:
4 MIN
or
12 MIN
Turn power OFF and ON
twice within 3 seconds
Set slide switch to:
TEST
6
Remote Light
(Receiver)
Make sure power is ON to
the remote light
Make sure power is ON to
the remote light
Turn the power OFF for
5 seconds, then back ON.
Make sure power is ON to
the remote light