Ultima Id Pro™ Operation; First Use; Turning On The Unit - MasterCool ULTIMA ID PRO 2 Manual Del Usuario

2
U
LTIMA
2.1

First Use

The Ultima ID Pro™ has a built in Lithium-ion battery. Prior to first use charge the battery for
a minimum of 4 hours with the included AC Power Supply. If a power outlet is accessible
you may also use the AC Power Supply to power the unit. The analyzer will function and
charge the battery while the AC Power Supply is connected.
2.2

Turning On the Unit

Press the left, soft key, 'POWER' button. The splash screen shown in (Figure 1) will appear
followed immediately by the screen in (Figure 2). If you wish to adjust factory settings press
'SET' and refer to section 3 Maintenance & Troubleshooting. If you do not need to adjust
the settings wait for the screen in (Figure 3) to appear. Connect the sample hose to the
analyzer and wait approximately 30 seconds for the unit to warm up. Once the analyzer
warms up you are ready for Calibration.
SOFTWARE VERSION
Manual Part Number:
5-06-7000-70-2
ID P
RO
ULTIMA ID PRO
453- XXXX-XXXX
Figure 1
CONNECT HOSE
TO ANALYZER
™ O
PERATION
TO CHANGE
SETTINGS OR
REPLACE PAPER
ROLL PRESS
Figure 2
Figure 3
Manual File:
MN-A-0289 Rev. E
SET
Page 2-15