High Side Liquid Sample Hose; Ac Power Adapter - MasterCool ULTIMA ID PRO 2 Manual Del Usuario

High Side Liquid Sample Hose

The 6.5 foot (2 meter) High Side Sample Hose configuration is constructed of a polyurethane tube
with an oil reservoir. A Brass Sample Hose Restrictor acts to transform Liquid refrigerant to Vapor
at the sample connection point while the High Pressure Liquid Sample Trap Assembly collects oil
and provides a means of expulsion after the test is complete. The syringe is provided with a
magnet for attaching it to the tank, an instrument inlet port mating connector on one end and a
SAE female flare coupling nut on the service end. The maximum pressure is 500 psig.
NOTE:
The analyzer will indicate "Non-Condensable" or "Unknown Refrigerant" if the analyzer
does not receive a good sample due to obstructed flow or lack of flow. If this occurs the Brass
Sample Hose Restrictor may need to be replaced.
Analyzer End

AC Power Adapter

The Ultima ID Pro™ is powered via a Lithium-ion battery. You can also power the unit via the 100-
240 VAC, 50-60 Hz power transformer. This transformer is included with each unit and converts a
standard 100-240VAC 50/60Hz wall outlet to 12VDC, 2.0A, which powers the device. This AC
Power Adapter will also charge the battery when connected to the analyzer.
NOTE:
Use of any other power source may cause damage to the unit and void the warranty.
Manual Part Number:
5-06-7000-70-2
Brass Sample
Hose Restrictor
Manual File:
MN-A-0289 Rev. E
High Pressure
Liquid Sample Trap
Assembly
Service End
(1/4 SAE Flare Nut)
A/C Power Cord
A/C Power Converter
Page 1-12
¼"