Ultima Id Pro™ Components; Ultima Id Pro™ Base Unit; Low Side Vapor Sample Hose - MasterCool ULTIMA ID PRO 2 Manual Del Usuario

1.3 Ultima ID Pro™ Components
Ultima ID Pro™ Base Unit
The Ultima ID Pro™ base unit houses the Graphic Display, Infrared Bench, Electrical Connections,
built in Lithium-ion Battery and Printer Module. These components require no maintenance;
therefore there are no serviceable components internal to the instrument. Disassembly will
void the warranty.
Print Door

Low Side Vapor Sample Hose

The 6.5 foot (2 meter) Low Side Vapor Sample Hose configuration is constructed of a polyurethane
tube. A Brass Sample Hose Restrictor acts to reduce pressure at the sample connection point and
reduce the introduction of harmful oil into the machine. The maximum inlet pressure is 500 psig.
The hose is provided with an instrument inlet port mating connector on one end and a
female flare coupling nut on the service end.
NOTE
: The analyzer will indicate "Non-Condensable" or "Unknown Refrigerant" if the analyzer
does not receive a good sample due to obstructed flow or lack of flow. If this occurs the Brass
Sample Hose Restrictor may need to be replaced.
Analyzer End
Manual Part Number:
5-06-7000-70-2
Control Panel
m
Manual File:
MN-A-0289 Rev. E
Air Intake Port
Brass Sample
Hose Restrictor
Sample Filter
¼"
SAE
Service End
(1/4 SAE Flare Nut)
Page 1-11