Sanus VLF613-B1 Manual Del Instrucciones página 14

STEP 2A
6
DRILL
4X
Be sure you drill into the CENTER of the stud.
CAUTION:
Drill the four pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of 3 ½ in. (8.9 cm).
14
(continued)
3 ½ in. (8.9 cm)
7/32 in.
(5.5 mm)
7
SECURELY TIGHTEN
15
17
4X
CAUTION:
Avoid potential personal injury or property damage!
All four lag bolts MUST BE firmly tightened to prevent
17
unwanted movement of the wall plate
securely fastened to the wall before continuing on to the next step.
Install the four lag bolts 17 and firmly tighten until they are pulled flush
against the wall plate/arm assembly
. Ensure the wall plate is
15
.
15
Go to STEP 3 on PAGE 18.