Dash Disassembly - Metra 99-9604 Manual Del Usuario

1. Unsnap and remove the trim panel
around the outside of the radio, switches,
and climate controls. (Figure A)
2. Remove (4) T-20 Torx screws to remove
the radio. (Figure B)
There are (2) different methods for
installing this kit. Option 1 does not require
the kit to be secured to the sub-dash
bracket whereas option 2 does. If choosing
option 1, skip to kit assembly. If choosing
option 2, proceed to the next step.
3. Using a pick tool, release (2) clips securing
the climate control switches . (Figure C)
3. Remove (6) T-20 Torx screws to remove
the radio sub-dash bracket: (2) at the
top, (2) at the bottom, and (2) inside the
cavity at the bottom. (Figure D)
Note:
It is not necessary to completely
remove the bracket and connectors. Kit
assembly can be performed inside the
vehicle to avoid this if so desired.
Continue to kit assembly
99-9604

Dash Disassembly

(Figure A)
(Figure B)
2
(Figure C)
(Figure D)