Kit Assembly - Metra 99-9604 Manual Del Usuario

ISO DIN radio provision with pocket
Option 1
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Attach the pocket to the lower
section of the radio brackets using
the (4) #8 x 3/8" Phillips pan-head
screws provided. (Figure A)
3. Slide the radio into the bracket/pocket
assembly, and then secure it using the
screws supplied with the radio. (Figure A)
Note: The screws must be flush in
the radio brackets in order to properly
slide into the factory sub-dash. (4)
5mm x 12mm Phillips flat-head
screws have been supplied if the radio
does not supply these type of screws .
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Test the radio
for proper operation .

Kit Assembly

5. Slide the completed assembly into
the dash.
Note: The radio will simply
compress in.
6. Attach the radio trim panel over the
radio and then secure it using the
(4) factory screws removed in dash
disassembly.
7. Reassemble the dash in reverse
order of disassembly.
(Figure A)
99-9604
Option 2
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Attach the pocket to the lower
section of the radio brackets using
the (4) #8 x 3/8" Phillips pan-head
screws provided. (Figure A)
3. Slide the radio into the bracket/
pocket assembly, and then secure it
using the screws supplied with the
radio. (Figure A)
Note: The screws must be flush in
the radio brackets in order to properly
slide into the factory sub-dash. (4)
5mm x 12mm Phillips flat-head
screws have been supplied if the radio
does not supply these type of screws.
4. Slide the completed assembly into the
factory sub-dash bracket removed in
dash disassembly, and then secure it
with the (4) #8 x 3/8" pan-head Phillips
screws provided, (2) on each side.
3
5. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for proper
operation.
6. Install the radio/sub-dash assembly
back into the dash using the (4)
factory screws removed in dash
disassembly.
Note: The (2) screws inside the
cavity will not be reused.
7. Attach the radio trim panel over the
radio and then secure it using the
(4) factory screws removed in dash
disassembly.
8. Reassemble the dash in reverse
order of disassembly.