Ingersoll Rand BP10P3–EU Manual De Instrucciones página 45

10. Install the Liner Cover O–ring (37) in the groove on
the large hub of the Rear Liner Cover (36). Align the
pin holes in the face of the Cover with the two Liner
Pins (40) at the rear of the Liner and place the Cover
against the Liner. A groove will be formed between
the Liner and Cover for the Rear Liner Seal (38).
Do not attempt to put the Seal in the groove at this
time.
11. Align the pin holes in the Front Liner Cover (56) with
the Pins in the front face of the Liner and place the
Cover against the face of the Liner. Another groove
will be formed between the Liner and Cover for the
Front Liner Seal (63). Install both the Front and Rear
Liner Seals in the grooves at this time and stand the
assembly on the workbench with the output end of
the Drive Shaft upward. (Refer to Dwg. TPD1288).
12. Apply a thin film of grease to the Liner O–ring (34)
and install it in the forward bore of the Housing.
13. Lubricate the Front and Rear Liner Seals and after
orienting the Housing to the proper position, install
the Housing over the Liner.
14. Grasp the flats of the Housing in vise jaws with the
output spindle downward. Remove the rear Liner
Cover Assembly and put grease in the central
opening of the Cover. (Refer to Dwg. TPD1289).
MAINTENANCE SECTION
LINER SEALS
(Dwg. TPD1288)
GREASE
(Dwg. TPD1289)
SAVE THESE INSTRUCTIONS. DO NOT DESTROY.
15. Reinstall the Cover Assembly and use a hex wrench
to push it below the threads at the rear of the
Housing. (Refer to Dwg. TPD1290).
16. Install the Housing Cap (35) and using the spanner
plug furnished with the Tool Kit, tighten the Cap
between 58–65 ft–lb (78–88 Nm) torque.
(Refer to Dwg. TPD1291).
SPANNER PLUG
17. Make certain the Drive Shaft rotates freely and then
fill the mechanism with fluid and reassemble the tool
as instructed in the section, CHANGING THE
MECHANISM FLUID.
18. After filling the mechanism with fluid, place the
mechanism on the hex hub of the Planetary Gear
Frame (23) and install the Mechanism Cover (66)
over the Drive Shaft (44) against the Motor Housing
(1). Install the four Mechanism Cover Mounting
Screws (69).
19. For Model BP10PQ1, insert the Bit Retaining Ball
(45) into the hole in the Drive Shaft. Install the Bit
Retaining Sleeve (46), Retaining Sleeve Spring (47)
and Spring Seat (48) on the output end of the Drive
Shaft. While compressing the Spring with the Seat,
install the Retaining Ring (49) in the groove on the
Shaft.
For Model BP10P3, insert the Socket Retaining Pin
(51) into the hole in the Drive Shaft and insert the
Retaining Pin Spring (52) into the end of the Drive
Shaft to capture the Pin.
45
PUSH DOWN
(Dwg. TPD1290)
CLOCKWISE TO TIGHTEN
(Dwg. TPD1291)