Charging The Battery - Ingersoll Rand BP10P3–EU Manual De Instrucciones

•
Before using the Battery Charger, read all instructions
on the Battery Chargers, Battery and cordless Impulse
Wrench.
To reduce risk of injury, charge only BP10P3–950
rechargeable batteries. Other types of batteries can
burst causing personal injury and damage. The use
of an attachment not sold or
recommended by the manufacturer of the Battery
Charger could cause fire, electrical shock or
personal injury. to reduce the risk of electric shock,
unplug the Battery Charger from the outlet before
attempting any maintenance or cleaning.
•
Do not expose the Battery Charger to wet conditions.
•
To prevent damage to electric cord and plug,
disconnect Battery Charger from electrical outlet by
pulling on plug rather than cord.
•
Make sure cord is located so that it will not be stepped
on, tripped over or otherwise subjected to damage or
stress.
When charging a Battery with any of the above
listed Battery Chargers, observe the following
procedures.
•
Do not charge Battery when temperature is below 50_F
(10_C) or above 95_F (35_C). Otherwise, battery life
will be shortened.
•
Never attempt to connect two Chargers together.
•
Models BP10P3–951–UL, BP10P3–951–CSA,
BP10P3–952–UL and BP10P3–952–CSA, are
designed to operate on standard 110V electrical
power. Do not attempt to use any other voltage.
Model BP10P3–951–EU is designed to operate on
standard 230V electrical power. Do not use any other
voltage.
•
Frequent charging can cause overheating. Wait 20
minutes between charging cycles if it is necessary to
charge Batteries after consecutive periods of use.
•
Do not insert foreign matter into the battery
receptacle on the Charger.
•
Do not use a booster transformer when charging.
•
Do not use an engine generator or DC power source
when charging a Battery.
•
Do not disassemble the Battery.
•
Do not store the Battery in locations where the
temperature may reach or exceed 10_F (40_C). Such
PLACING TOOL IN SERVICE
4
locations and conditions might include outside sheds or
metal buildings during the summer.
•
Do not short circuit the Battery.
Do not incinerate the Battery even if it is severely
damaged or is completely worn out. The Battery
can explode if placed in a fire. Battery leakage can
occur under extreme usage or temperature
conditions. If liquid which has leaked from the
Battery comes in contact with skin, wash
immediately with soap and water and then with
lemon juice or vinegar. If liquid gets in the eyes,
wash with a strong solution of boric acid and get
medical attention immediately.
Disposal of Worn Out Battery
Return the worn out Battery to the distributor from which it
was purchased as soon as the post charging battery life
becomes too short for practical use.

Charging the Battery

Use only the models of Battery Chargers listed in the
section of this form PLACING THE TOOL IN
SERVICE, for charging the BP10P3–950 Battery.
For continuos service of the Impulse Tool, a spare Battery
should be kept on hand for alternate use.
During the initial charge or after the Battery has not been
used for a long time, the Battery may not take a full charge.
If this occurs, use the Battery in the Impulse Tool again
before resuming the charging cycle. It should then accept a
full charge.
1. Disengage the Battery by depressing the button on the
Battery to release the latch and then pulling the Battery
out the bottom of the housing handle.
2. Insert the AC power cord of the Battery Charger into
the power receptacle.
3. Insert the Battery into the charger making sure that the
positive (+) and negative (–) sides are properly
oriented. The Charger has a series of lines embossed
to match the lines on the battery when the Battery is
properly positioned. Additionally, the Battery will not
fully enter the Charger if the orientation is off 180_
from correct insertion. When properly inserted, the
power indicator light will remain red.