Implanting The Sensor; Care And Maintenance; Technical Specifications - Kärcher SensoTimer ST6 eco!ogic Manual De Instrucciones

Implanting the sensor

 Figure A1
The sensor surface must have contact
with the soil. For this purpose, the sen-
sor is inserted in the loose ground like a
plant and the soil is pressed around it.
 Do not step or hammer on the sensor.
 Figure A2
Implant the sensor directly in the irriga-
tion area and ensure that the sensor is
not located in a sink or elevation.

Care and maintenance

Maintenance
 Figure 2, 4, B
Recommendation: Replace the batter-
ies of the control unit and the sensor as
well as the sensor pad annually.
 Completely drain all water from the irri-
gation device.
 Remove the batteries from the sensor
and the control unit.
 Store the irrigation device at a dry and
frost-proof location.

Technical specifications

Operating pressure
Max. feed temperature 35
Ambient temperature
Frequency
Radio range (max.)
Battery type
Subject to technical modifications!
16
Storage
0,1 - 1,0 (1
- 10)
+5 -> +60 °C
868,1
100
9V (6LR61 /
Alkaline)
MPa
(bar)
°C
MHz
m
– 6
EN