Nice OVBT Instrucciones Y Advertencias Para La Instalación Y El Uso página 6

INSTALLING THE COMMUNICATION
3
MODULE
3.1 - OVBT module (Bluetooth
This module uses Bluetooth ®
between Oview and the computer device (on which the software is
installed). In particular, the device must be equipped with a Windows
operating system (see requirements in paragraph 4.1) and with a
Bluetooth ® connection. In general these devices are PCs (desktops
or laptops), palmtop computers, smartphones (a palmtop with mobile
phone) and similar devices. Communication is possible up to a maxi-
mum distance of about 10-15 m in the absence of obstacles.
To install the module on Oview, refer to fig. 2.
To activate the connection between Oview and the computer device,
proceed as follows:
01. Activate the Bluetooth ® connection on the computer. Caution! – If
the computer is not equipped for a bluetooth
external bluetooth ® adapter with USB socket must be fitted and
configured as described in its installation manual. The use of
bluetooth USB adaptors that support Microsoft
®
m ® /Broadcomm ® drivers is recommended.
02. On Oview, select "menu" on the initial screen, then "settings": the
list of available parameters appears;
03. Select "communications" then "bluetooth";
04. now enter the required data in the fields that appear:
- "Passkey bluetooth" - this is the password for the bluetooth
module (factory setting "0000"). It is advisable to enter a personal,
secret number to prevent access to the module and therefore to
Oview by unauthorised persons while Oview is connected to the
computer. Important! - Don't forget the new password, otherwise
you will be unable to gain access to Oview.
- "Pairing list" - the computer password when it connects to the
4 – English
® )
technology for wireless communication
® configuration, an
or Widcom-
®
module the first time is recorded in this list. So it is possible at any
time to remove from this list the passwords of devices that are no
longer authorised to connect directly to the module without enter-
ing a password.
05. Install the software on the computer (refer to chapter 4) and finally
run the software.
Important! - If this is the first time that the connection is made,
read points 06 and 07 below; if the connection has previously
®
been made, read only point 07.
06. The window shown in fig. 3 appears. In this window, select the
Oview name, enter the same password that has been entered in
point 04 and press "ok".
07. The "remote mode" screen appears on Oview, confirming that the
connection is in progress. On the computer the software automat-
2
®