Nice OVBT Instrucciones Y Advertencias Para La Instalación Y El Uso página 7

ically opens the initial screen ready for a work session.
3.2 - OVBTGSM module (Bluetooth
This module allows Oview to communicate with the computer device
(on which the software is installed) using two different communication
technologies: Bluetooth ® technology for short range connection (max-
imum 10-15 m) and GSM ® /GPRS
connection in areas with Internet coverage (GSM/GPRS network). In
particular, the device must be equipped with a Windows
system (see requirements in paragraph 4.1), with Internet access
and with a bluetooth ® connection. These devices are usually PCs
(desktops or laptops), palmtop computers, smartphones (a palmtop
with mobile phone) or similar devices. Furthermore, a mobile phone
can be used to make the automation perform certain elementary oper-
ations by means of a phone call or text message.
3
® / GSM ® / GPRS ® )
® (internet) technology for long range
® operating
Note to Fig. 3:
the names displayed in the window shown
in fig. 3 depend on the devices connected.
A
3.2.1 - Installation and configuration of OVBTGSM module for
"Gsm/Gprs" connection
01. Obtain a SIM card for mobile phones from the mobile phone com-
pany of your choice.
02. Insert the SIM card in a mobile phone and set: a) the Service Cen-
tre of the phone company for text messages; b) the APN number
provided by the phone company for Gprs communication (de-
pending on the chosen phone company, registration may be
required). Important! - Keep a record of this number.
03. Remove the SIM card from the mobile phone and insert it in the
module via the slot on the front (fig. A).
04. Fit the module on Oview as shown in fig. 2.
05. Connect Oview to the "BusT4" socket of any powered-up control
unit.
06. On the Oview initial screen, select "menu", then "settings": the
list of available parameters appears
07. Select "communications" then "Gprs".
08. Enter the following data in the fields that appear:
- "GSM Pin" - enter the PIN number of the SIM card inserted in
the module;
- "GSM APN" - enter the same APN number as the one memo-
rised in point 02 (registration may be required depending on the
chosen phone company);
- "GSM no. Tel" - enter the telephone number of the SIM card
inserted in the module.
- "GSM Port" - enter the number of the port that will be used for
Gprs communication. The number 80 is recommended. If howev-
er communication is not active at the time of making the connec-
tion, choose another number between 1 and 65,535.
- "GSM Password" - enter a personal password (maximum 6 dig-
its) that will be used by Oview to validate the password contained
in the text messages sent to the automation.
The settings described in point 08 allow you to:
English – 5