Connecting The Units; Power Cable Connection - Pioneer DEH-P800BT Manual De Intalación

Connecting the Units

Power cable connection

The pin position of the ISO connector will differ depends on the
type of vehicle. Connect 6* and 7* when Pin 5 is an antenna
control type. In another type of vehicle, never connect 6* and 7*.
Note:
Depending on the kind of vehicle, the function
of 3* and 5* may be different. In this case, be
sure to connect 2* to 5* and 4* to 3*.
3*
5*
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this
case, be sure to connect to both
connectors.
3
1*
2*
4*
Cap (1*)
Do not remove cap if this
terminal is not in use.
Yellow (3*)
Back-up
(or accessory)
Red (5*)
Accessory
(or back-up)
Notes:
• Change the initial setting of this unit (refer to the Operation
• When using a subwoofer of 70 W (2 Ω) , be sure to connect
Microphone
4 m
iPod with Dock
Connector
Dock connector
Connect leads of the same
color to each other.
Yellow (2*)
Connect to the constant 12 V
supply terminal.
Red (4*)
Connect to terminal controlled by
ignition switch (12 V DC).
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
Manual). The subwoofer output of this unit is monaural.
with Violet and Violet/black leads of this unit. Do not connect
anything with Green and Green/black leads.
Antenna jack
15 cm
Dock connector port