Operating Controls; Operating Times; Start-Up; Assembly - MTD GT40 Manual De Instrucciones

EN

Operating controls

Operating controls K
1 Power pack release
2 Lock-on switch
3 On/off switch on handle
4 Speed switch
5 Locating button edge cutting function
6 Working angle adjustment locating knob
7 Protective cover
8 Plant protection bow
9 Spool cap
10 Line spool
11 Line box
12 Guide wheel
13 Line Cutter
14 Middle handle
15 Handle
16 Power pack
Supplementary documentation
Make sure the operating manuals of the
40V FAST CHARGER and the 40V LI-ION
power pack are available. Please read
and understand them before putting the
device into use.
Power pack charging
Risk of injuries or material damage
¾ Only charge the power pack with the 40V
FAST CHARGER.
Attention!
The power pack is supplied partially charged. Be-
fore first use, fully charge the power pack using the
40 V FAST CHARGER to ensure the full capacity
of the power pack.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.

Operating times

Observe the times stipulated in local byelaws.
Î
Check with your local authorities to determine if
Î
there are any operating time limitations.
20

Start-up

WARNING!

Assembly

Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
line.
¾ Always remove the power pack prior to
working on the device.
Attaching the protective cover A B
Position the protective cover
Î
trimmer B 1 .
Screw on the protective cover with the supplied
Î
screws A b B 2 .
Note
A guide wheel B [1] is pre-mounted on the
protective cover, which enables easier
working with the edge-cutting function.
Middle handle A C
Remove the two pre-fitted screws and the fit-
Î
ting A c .
Position the middle handle at the desired
Î
height C 1 .
Locate the fitting on the opposite side of the
Î
middle handle C 2 .
Secure the middle handle by tightening the
Î
screws C 3 .
Connecting the trimmer unit to the operating
arm D
Insert the trimmer unit in the holder of the oper-
Î
ating arm 1 .
Attention!
Note the polarity markings of the contacts.
Fully tighten the fastening sleeve 2 .
Î
Operating controls
WARNING!
on the
A a