Troubleshooting; Warranty; Ce Declaration Of Conformity; Environmentally-Friendly Disposal - MTD GT40 Manual De Instrucciones

Troubleshooting

Risk of injuries or material damage
¾ In case of doubt always consult a specialist workshop.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause
The device switch- The power pack is too hot.
es off.
The power pack is discharged.
The temperature of the device (electronics)
is too high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overcurrent release
Power pack temperature too high or too low. Allow the power pack to cool down or heat
The power pack is defective.
Automatic line The spool is empty.
adjustment does
The toothing between the metal knob and the
not work.
line spool is dirty.
The line has torn off and is pulled into the
line spool.
The line has become caught in the spool.
The line is welded onto the spool.
The line breaks off The line comes into contact too frequently
too frequently. with fixed objects, e.g. fences, trees, etc.
Strong vibrations Device fasteners have come loose.

Warranty

The warranty conditions of our local company or
importer apply in all countries. Under the terms of
the warranty we will repair faults on your device
free of charge, insofar as material or manufactur-
ing defects are the cause. To make a claim under
warranty please contact your seller or your nearest
branch.

CE Declaration of Conformity

Further details about the device are con-
tained on the separately enclosed CE
Declaration of Conformity, which forms part
of this instruction manual.
Troubleshooting
WARNING!
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary,
clean the ventilation slots
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
up.
Replace the power pack.
Replace the line spool.
Use a brush to remove dirt from the parts.
Take off the line spool, if necessary rewind
the line by gently pulling and insert the spool.
Remove the welded line part, if necessary
rewind the line by gently pulling and insert
the spool.
Use the plant protection bow.
Consult a specialist workshop.

Environmentally-friendly disposal

Electrical tools, accessories and packaging must be
routed into an environmentally compatible recycling
chain.
Power packs/batteries:
Do not dispose of power packs/batteries
in domestic waste, by burning or throwing
into water. Power packs/batteries must be
collected, recycled or disposed of in an
environmentally friendly manner.
Power tools:
Do not throw your power tool away with
domestic waste! Take it to a disposal
facility.
EN
23