Sony HT-CT550W Manual De Instrucciones página 14

Ocultar thumbs Ver también para HT-CT550W:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installing the speaker on a
wall
You can install the speaker on the wall.
Notes
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a wall beam. Install the
speaker on a vertical and flat reinforced area of the
wall.
• Be sure to subcontract the installation to Sony dealers
or licensed contractors and pay special attention to
safety during the installation.
• Sony is not responsible for accidents or damage
caused by improper installation, insufficient wall
strength, improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that are
suitable for the holes on the back of the
speaker. See the illustrations below.
more than 25 mm (1 inch)
5 mm
(1/5 inches)
10 mm
(2/5 inches)
Hole on the back of the speaker
2
Fasten the screws to the wall. The
screws should protrude 6 to 7 mm
(approx. 1/4 inches).
6 to 7 mm
(approx. 1/4 inches)
14
US
4 mm (1/6 inches)
265 mm
(10 2/5 inches)
3
Hang the speaker onto the screws.
Align the holes on the back of the speaker to
the screws, then hang the speaker onto the
two screws.

Publicidad

Tabla de contenido
loading

Tabla de contenido