Payout Assemblies; Removing The Payout Assy - NAMCO bee panic Manual Del Operador

8-13

Payout Assemblies

8-13-1 Removing the Payout Assy

1. Remove the Upper Rear Door.
2. Disconnect the 2 connectors and disconnect the Earth connector.
3. Loosen 1off cap screw (M5x12) located under the Payout Assy. Remove 2off cap
screws (M5x12) located on both sides of the Payout Assy.
Earth connector
4. Lift the Payout Assy to clear the bottom screw and remove the Payout Assy.
5. Reassemble in reverse order.
Cap screws (M5x12)
Cap screw (M5x12)
(to be loosened only)
Connector
Page 74
Connector