Notes On Installation; Adjusting The Level Adjusters - NAMCO bee panic Manual Del Operador

5-1

Notes on Installation

l l l l l
WARNING •
l l l l l
WARNING •
l l l l l
WARNING •
i
CAUTION •
NOTE •
•
5-2

Adjusting the Level Adjusters.

When the game is in it's final position, lower the two level adjusters, with a spanner, so
that the castors are raised from the floor by approx. 5mm. Tighten the lock nut with a
spanner to ensure that the Level Adjusters do not move.
Approx. 5mm
NEVER turn the power to the machine ON until installation
has been completed.
In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
So that customers are not injured , ensure that there is at
least 500mm separation between other machines or walls.
In order to avoid damage to the machine due to mis-operation,
ensure that the voltage of the mains supply is 230volts AC.
If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level adjusters
to prevent the machine sliding on the floor.
In order to gain access to the Power Supply and CPU assemblies,
make sure that the rear of the machine is separated from a wall
or other machine by at least 500mm.
Cabinet
Castor
Page 36
Adjustable Foot