NAMCO bee panic Manual Del Operador página 85

4. Disconnect the connector.
5. Using needle nosed pliers, squeeze the locking tabs of the locking supports, one
at a time, to release the PC Board. Remove the Xenon PC Board.
Xenon PC Board
How to disengage
locking supports
PC Board
Locking Support
Stopper
6. Reassemble in reverse order.
Note: To prevent possible electrical damage, ensure that connectors are
refitted the correct way round.
In order to ensure the correct light output from the gun Assy, the
fibre-optic should be fitted as close as possible to the Xenon Tube.
When installing the fibre optic, be careful not to touch the Xenon tube
with your fingers or hands. If the Xenon tube is accidentally touched,
clean the area touched with alcohol. (Part No 95000031)
Insert the Fibre Optic until
it comes in contact with
the stopper in the holder
and install it so that it is as
close as possible to the
Xenon Tube.
Xenon PC Board
Locking Supports
Needle-Nosed
Pliers
Fibre Optic
Page 85
Holder
Xenon Tube