Replacing The Gun Harness - NAMCO bee panic Manual Del Operador

8-14-3 Replacing the Gun Harness

1. Remove the Gun Assy.
2. Remove 2off cap screws (M3x6) that hold the Harness Guide in place, and
detach the Harness Guide from the Pipe Bracket.
3. Remove 1off pozi button head screw (M5x20) and hex nut (M5).
4. Remove the Pipe Clip, Pipe Bracket and O-ring.
O-Ring
Pipe Clip
5. Remove 1off cap screw (M3x20), 1off cap screw (M3x8), 2off hex nuts (M3) and
separate the Hand Protectors (L) and (R).
Hex nut (M3)
Hand Protector (L)
Hand Protector (R)
6. Remove Gun Body (R).
(see 8-14-1 page 77)
Harness Guide
Hex nut (M5)
Pozi button head screw
(M5x20)
(see 8-14-2 (1) page 79)
Page 81
Pipe Bracket
Cap screw (M3x8)
Cap screw (M3x20)