Test Mode; Output Test - NAMCO bee panic Manual Del Operador

7-2

Test Mode

1. Open the coin door and slide the test switch "ON".
2. The 7-segment display indicates the name of the current Test. Each time the
Select switch is pressed the test steps through in the following order.

(1) Output Test

(2) Input Test (I
(3) Dispensing Operation Counter (p
(4) Selecting Operation Counter (s
(5) Payout Motor Test ( )
(6) Sound Test (se)
The figures in brackets () are the Test Mode names shown in the
7-segment display.
3. When the Select switch is pressed whilst in Test (6) 'Sound Test', the Test Mode
returns to Test (1) 'Output Test'.
4. After testing is completed, slide the test switch to the "OFF" position to return to
normal game mode.
The Test Switch must always be in the "OFF" position for normal game mode.
7-2-1 Output Test
When this test is selected, the following sequences will automatically operate.
To discontinue this test and step to the next test press the Select switch.
Selection switches 1 and 2, and Challenge switch flash simultaneously at one
•
second intervals.
The white lamps and 7-segment displays light on all Target Assys. After two
•
seconds, the white lamps turn off, and all the red lamps light for two seconds.
After all lamps and 7-segment displays have turned off for one second, the red
lamp, white lamp, and 7-segment display flash in order starting from Target Assy
1 and ending with Target Assy 10 at one second intervals.
(The 7-segment score display shows "11" when Target Assy 1 is illuminated, "22"
when Target Assy 2 is illuminated, ..... and "00" when Target Assy 10 is
illuminated).
The 7-segment score display turns off for one second after showing "888" for four
•
seconds, it then shows "111", "222", ..... "000" at one second intervals.
Pulling the Gun Trigger will produce a shot sound and the xenon light is emitted.
•
)
c c c c c
)
n n n n n
c c c c c
Page 45
)
n n n n n