Publicidad
Idiomas disponibles
Idiomas disponibles
4. Install (2) Tether Attachments- Measure from mark on
carpeting forward in vehicle 0.5 inch (13 mm) (See Figure
4a) and cut an incision 1.5 inches (40 mm) wide in carpet.
Next, 2 inches (50 mm) forward in the vehicle from that
location cut a second incision 1.5 inches (40 mm) wide in
the carpet. Repeat at other original mark in carpet. (See
Figures 4b and 4c).
FIGURE 4A
FIGURE 4B
Tether Installation- Insert snap end of tether through forward slot
and out the rearward slot (See Figure 4b and 4c). Next, place
the organizer back into position.
Then, lift back of organizer to install both Tree Fasteners (lo-
cated on the end of the tether) into the holes located on the third
rib of each side, insuring that the Tree Fasteners point towards
the center of the organizer (see Figure 4d). Finish by snapping
the other end of the tether onto the snaps on the back of the
organizer and tuck the excess tether material back under the
organizer (see Figure 4e).
Chevrolet Corvette Organizer Installation
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
FIGURE 4C
50 mm
40 mm
REVISION
AUTH
FIGURE 4D
FIGURE 4E
5. Firmly place pressure in forward area of your organizer and
make sure the Velcro® Disks engage with each other.
6. Place Bin Inserts into all three bins. CGA Logo of Center
Bin Insert should face the front of vehicle when properly
inserted.
NOTES:
•
This Cargo Organizer is compatible with the Genuine Cor-
vette Accessory behind the seat Storage Pouch.
•
If use of the child tether is required for the passenger seat
then you must remove the Cargo Organizer to access and
use the child tether anchor.
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Chevrolet Corvette Organizer Installation
PART NO.
19154791
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19154791
SHEET
2
SHEET
2
6
OF
6
OF
Publicidad
