GM 19157723 Instrucciones De Montaje

GMX245 Corvette Spoiler
Contents
Description
Rear Spoiler
Screws
Tinnerman Clips
M4 Washer Nut
Drill Template
Tools Required
Socket to remove existing stop lamp
10mm Socket
Drill
7mm Drill Bit
Vehicle Preparation
Must be at ambient temperature for tape adherence.
After Installation
Must remain at ambient temperature for tape to set for 24 hours.
Installation Procedure
1. Remove all lamp assemblies. See Figure 1 for Spoiler Lamp
reference.
FIGURE 1
TINNERMAN CLIPS (4)
2. Using the access through the inner lamp hole, remove the 4 nuts
of the center high mounted stop lamp (CHMSL).
3. Remove original equipment (OE) Spoiler and disconnect electri-
cal.
4. Remove studs and lamp from OE spoiler and replace lamp in
accessory spoiler using the 2 screws provided in this package.
Add 4 tinnerman clips and the 2 studs from the original spoiler to
spoiler as shown in Figure 1 and 2.
GMX245 Corvette Spoiler
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 28MR06
WHITE 16 POUND NON-BOND
10SE07 R
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
2
4
4
1
M6 STUDS (2)
REVISION
In
FIGURE 2
TAPE
5. Locate template to fascia as explained on template.
6. Drill 4 outboard holes, drilling pilot holes first then enlarging.
7. Carefully, cut notch on center of fascia at location of template for
clearance of electrical. See Figures 3A, 3B and 3C.
FIGURE 3A - CROSS SECTION
LOCALLY NOTCH FASCIA
FIGURE 3B
ELECTRICAL
BEFORE
OPENING
FIGURE 3C
AFTER TRIM
PART NO.
REV 10SE07
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
GMX245 Corvette Spoiler
PART NO.
19157723
6200 Grand Pointe Dr., Grand Blanc, MI 48439
SLIDE TINNERMAN
CLIPS ON
TAPE
TRIM TAB
19157723
SHEET
1
SHEET
TAPE
SPOILER
FASCIA
1 6
OF
6
OF