GM 19154791 Instrucciones De Montaje

Corvette Organizer
Tools required:
Carpet Knife
Measuring Tape
Parts Included:
Organizer
(3) Bin Inserts
(2) sets Velcro® Attachment Disks
(2) tethers.
Installion Instructions
1. Begin by reclining driver and passenger seats forward and
opening rear hatch.
2. Install (2) Velcro® attachment disks. See Figure 1. Place
Velcro® Discs with adhesive backing to organizer as indi-
cated below.
FIGURE 1
BOTTOM OF PART - ADHERE DISCS IN FORWARD, LOWER,
INSIDE CORNER OF THE TWO SMALL STORAGE BINS.
PRESS FIRMLY TO ENSURE SECURE.
Next, measure for placement of the Velcro® Screw Augers (See
figure 2a). On driver side, measure and mark 11 inches (280
mm) inboard from speaker trim panel (See Figure 2b) and 1.75
inches (45 mm) from the floor. Where marked, cut a small
incision (with carpet knife) and screw Velcro® Augers into place
by hand (See Figure 2c). Repeat this step on passenger side.
Chevrolet Corvette Organizer Installation
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 19JL05 I
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION AUTH
FIGURE 2A
FIGURE 2B
11"
3. Place organizer in vehicle position as shown in Figure 3 and
press down firmly to make impression into carpet.
FIGURE 3
This creates outline of the organizer in the carpet required for
necessary measurements. Mark carpet area (2 places) right
below each of the 2 snaps (See Figure 3). Next, remove part.
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Chevrolet Corvette Organizer Installation
PART NO.
19154791
6200 Grand Pointe Dr., Grand Blanc, MI 48439
STEP 2 SCREW
AUGER LOCATIONS
FIGURE 2C
SCREW AUGER
SNAPS
19154791
SHEET
1
SHEET
1
6
OF
6
OF