Pairing
Before use, you must pair the headset with your cell phone. Pairing will create a stored
connection in both the Z9 and your Bluetooth cell phone. Pairing need only be done once,
when first connecting to a new phone. The Z9 can store pairing information for up to three (3)
different Bluetooth devices. If you wish to pair another different device once 3 devices are
paired, you will need to RESET the Z9 as per the instructions in Basic Headset Functions
below.
Pairing Procedure
This is an example only and may differ from your phone, but the process will be the same.
1.
First turn the phone OFF and then back ON again to refresh its memory.
2.
Bring the mobile phone to about 30cm from the Z9 Dual Microphone.
3.
Find the Bluetooth menu in your mobile phone. Turn Bluetooth ON. (Check your mobile
phone user guide if necessary)
4.
With the Z9 OFF, Press and Hold the MFB
a solid Blue, and then will start flashing. The Z9 is now in Pairing mode and ready to be
found in searches by other Bluetooth devices. Pairing mode will be active for 2 minutes.
for about 6 seconds. The LED will appear