Oven Installation; Mounting Plate - Viking VMOH330SS Guia De Instalacion

STEP 4
• Place the blower unit into the opening.
• Secure the Case Blow Fan Top, the blower motor and
cover to the microwave oven with the screws (1, 2 and
3) from Steps 1 and 2. See Figure 15.
• Carefully match the exhaust opening location of the
microwave and attach the damper to blower motor cover
by sliding it into the guides at the blower motor cover.
See Figures 16, 17.
Be sure that the damper hinge is on the front and the
damper swings free into the wall outlet.
1.TINSKB278MRR0_Viking_VMOH330SS_OTR_Install_E,S,F.indd 7
Figure 15
Figure 16
Figure 17

8 OVEN INSTALLATION

THIS OVEN CANNOT BE PROPERLY INSTALLED WITH-
OUT REFERRING TO THE MOUNTING INSTRUCTIONS
FOUND ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON
BOTH TOP CABINET AND WALL TEMPLATES.

MOUNTING PLATE

STEP 1 - SETUP POSITION
• Draw a line down the middle of the studs (see Wall
Construction, page 3).
• Draw a vertical line on the wall at the center of the 30"
wide space. See Figure 18.
NOTE: Use the wall template for the rear wall. Reference
Wall Template prior to proceeding. Installation of this
product requires 2 people.
Power Supply Cord Hole
House Duct
STEP 2 - DRILLING
Reference the Wall Template.
STEP 3 - TIGHTENING THE SCREWS
To attach the mounting plate to the wall using the toggle
bolt assemblies and/or lag screws:
• Insert toggle bolts through mounting plate at required
locations and add the spring loaded toggles. See
Figure 19.
Be sure you leave space at least the thickness of the wall
between the mounting plate and the end of the toggle
nut, (in closed position). If you do not leave this space,
the toggle nut will not open on the other side of the wall.
E 7
Mounting Plate
Figure 18
Figure 19
1/31/19 11:07 AM