Publicidad
Idiomas disponibles
Idiomas disponibles
(Figure 2)
Note: if the room temperature is very warm, the appliance may work continually and a layer of frost will deposit on the back of the fridge
compartment, in this case, turn the knob to lower settings (1-2).
This system comprises
Remove the pin and bushing from the top
panel.
1
Remove the bottom door.
4
Fit the hinge and doors, working from top to
bottom 1
2
3
7
DEFROSTING
The fridge compartment is automatically defrosted when the compressor is not
working.
A small amount of frost or drops of water on the back of the fridge compartment when
the fridge is working is normal.
Make sure the water outlet is always clean. Make sure foods do not touch the back or
sides of the fridge.
We recommend you defrost the freezer compartment when the frost is more than 3 mm
thick.
NB. This is the rating plate. If you need to contact our Service Department in the
event of faults, remember to give them the information on the plate.
DRAINING WATER
The appliance has a system for draining water from defrosting.
REVERSING THE FRIDGE-FREEZER DOORS
Remove the top door.
2
Remove the pin of the bottom right-hand hinge
and refit it on the bottom left-hand hinge.
5
A bar to remove when defrosting so water can
flow into a basin.
A drainage basin (not
supplied).
2 GB
Remove the middle hinge and washers.
3
Reverse the bracket cover snap, which is
snap-fitted on the bracket.
6
Publicidad
