WAGNER ROLL'N GO Manual Del Propietário página 3

3. Attach one end of hose to roller handle. Make sure hose
clip is in place (a). Attach small air hose to handle (b).
(b)
5. Place lid onto material container. Align groove (d) and
hole (e) with the handle of the material container as
shown.
NOTICE - Use drop cloths to protect your floors and
furnishings.
7. Assemble core (f), roller cover (g), and cap (h). Attach
roller assembly to arm, making sure the roller assembly
snaps into the locking tab (i) as shown.
(f)
(g)
(h)
Setup (continued)
(a)
(d)
(e)
(i)
4. Attach small air hose to fitting on base (c).
6. Place material container onto the base. Hook the strap to
one side of the base and bring the strap over the groove on
the lid. Secure hook to other side of the base. Insert suction
hose through the hole in the lid and into the material.
NOTICE - Do not carry the unit around by the strap. Use
the material container handle.
8. Press the quick-release tabs on the handle (j) and attach
arm to the handle. When using the extension, attach the
arm to the extension, then attach the extension to the
handle. If painting a ceiling, attach spatter shield.
3
(c)
(j)
English