HoMedics enviraScape Manual De Instrucciones página 4

IB-WFLMWALL-1110-01_Layout 1 17/12/2010 12:27 Page 4
ASSEMBLY AND INSTRUCTIONS FOR USE :
1. Unpack the product from the package carefully. Keep packing material for safe storage
2. Familiarise yourself with the pump (B). The pump speed is controlled by the switch located at
the front of the pump. The speed (Fig. 2) is indicated by a plus (+) and minus (-) sign. To
increase the speed, move the switch slowly toward the plus sign. You will hear a click as the
switch moves to each speed level. At its highest speed level, the switch will cease to move
any further. To decrease the pump speed, move the switch toward to minus sign.
3. Note: it is recommended that the pump be set at its highest speed during assembly and later
adjusted to a lower setting if required. Ensure pump is unplugged before adjusting. Ensure
the water level is kept above the minimum water level at ALL TIMES.
4. Place the BASE (A) on a flat surface
Fig. 1
C – Fountain Top
Fig. 2
Clean Water
Platform
A – Base
E – Light Bulb
B – Pump
Minimum Water Level
D – River Rocks
Cord
Slot
Flow Control Valve
(+) faster water
output
(-) slower water
output
4
F – Power Adaptor
Switch
Power Cord