HoMedics enviraScape Manual De Instrucciones página 7

IB-WFLMWALL-1110-01_Layout 1 17/12/2010 12:27 Page 7
MAINTENANCE :
To clean the pump:
Unplug from electrical
outlet. Remove it from the
base of the fountain. Use
a small brush or stream
of water to remove any
debris (Fig 9).
To keep water clean:
Periodically change water
and clean the product
according to the water
condition. Keeping the
water clean prevents the
water from becoming
sticky and forming micro-
organisms.
To clean off hard water deposits on the base or rocks:
Soak the container and rocks in a mixture of vinegar and water to clean and remove any mineral
build-up.
Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to avoid shortening the life of the
pump.
NOTE: Never let the pump run dry, as this will shorten the life of the pump.
Fountain Storage
Unplug the fountain from the electrical outlet, empty the water, and store rocks and fountain in a
dry, cool place.
Changing light bulb
First, unplug fountain and let bulb cool down. Remove the bulb from the rubber plug of the
plastic tube. Pull the rubber plug together with the bulb cover out from the plastic light tube and
slowly pull apart. Use caution with glass bulb cover. Insert the rubber plug back into the plastic
light tube. Pull bulb
straight out from rubber
neck. Replace with new
bulb, inserting prongs into
the holes. Place bulb
cover securely onto
rubber neck and slide
together into rubber of
plastic light tube (Fig 10).
Figure 9
Pump Inlet
Front Plate
Flow
Control
Lever
Figure 10
7
PVC Tubing
Inserts Here
Impeller
Suction Feet
Glass tube
Back Plate
Housing