Setting The Clock - Jensen MP1314 Manual Del Propietário

MP1314
• PI SOUND: To change stations the other station is played for less than one
second.
• PI MUTE: The alternate station is muted.
5. RETUNE L/S
Use the volume knob (10) to set the retune short or long function. The retune
short (RETUNE S) or retune long function (RETUNE L) sets the delay for the
automatic search for traffic announcements and/or program information. This
feature reduces gaps in radio reception during searches:
• S (short) after approximately 30 seconds;
• L (long) after approximately 90 seconds.
6. MASK DPI/ALL
Use the volume knob (10) to set the MASK DPI or MASK ALL search function.
You can adjust the search function to:
• DPI : Alternative frequencies with different Pl code are excluded from the
search.
• ALL : Alternative frequencies with different Pl code and no RDS information
with high signal level are excluded from the search.

Setting the clock

1. Briefly press the DISP button (9) until the clock is shown on the display.
2. Hold the DISP button (9) until the clock flashes.
3. Briefly press DISP button (9) to select the hours.
4. Rotate the volume knob (10) to set the hours.
5. Briefly press DISP button (9) again to select the minutes.
6. Rotate the volume knob (10) to set the minutes.
Equalization Settings
Press EQ button (8) briefly to turn on equalization function and to select desired
audio mode. There are five equalizer settings:
FLAT
Mute
Press the Power On/Off ( )/MUTE button (7) momentarily to mute the audio
volume from the unit (MUTE will appear on the display panel). Pressing the Power
On/Off ( )/MUTE button (7) again or adjusting the volume level will return to the
volume level setting in use before the mute function was activated.
Electronic Skip Protection (ESP) Function
The unit will absorb bumps to prevent playback skips while playing discs.
CLASSIC POP ROCK EQ OFF
15