Installing The Unit - Jensen MP1314 Manual Del Propietário

MP1314

Installing the unit

Be sure you test all connections first, and then follow these steps to install the unit.
1. Make sure the ignition is turned off, and then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Press the release button on the front panel and remove the control panel
(refer to "removing the front panel").
4. Lift the top of the outer trim ring then pull it out to remove it.
5. The two supplied keys release tabs inside the unit's sleeve so you can remove
it. Insert the keys as far as they will go (with the notches facing up) into the
appropriate slots at the middle left and right sides of the unit. Then slide the
sleeve off the back of the unit.
(1) Front panel; (2) Outer trim ring; (3) Sleeve; (4) L key; (5) R key
6. Mount the sleeve by inserting it into the opening of the dashboard and bend
open the tabs located around the sleeve with a screwdriver. Not all tabs will be
able to make contact, so examine which ones will be most effective. Bending
open the appropriate tabs behind the dashboard to secure the sleeve in place.
5