Electrolux EWF 127450 W Manual De Instrucciones página 10

10 electrolux
Start the programme by pressing button
8
To start the selected programme, press the
button 8 , the green pilot light of the button
8 stops blinking.
To interrupt a programme which is running,
press the button 8 : the green pilot light starts
blinking.
To restart the programme from the point at
which it was interrupted, press the button 8
again . If you have chosen a delayed start,
the machine will begin the countdown. If an
incorrect option is selected, the red pilot light
of the button 8 blinks for 3 times the message
Err is displayed for a few seconds.
Select the Time Manager option by
pressing buttons 10
By pressing these buttons repeatedly, the
duration of the washing cycle can be in-
creased or decreased. The soil level icon will
appear on the display to indicate the chosen
degree of soil. This option is available only
with Cotton , Synthetic and Delicate pro-
grammes.
Soil Level Icon
Intensive
Normal
Daily
Light
Quick
1)
Super Quick
1)
2)
Refresh
Super Re-
2)
1)
fresh
1) We recommend you to reduce the load sizes (see
Washing programmes table).
2) When you select this option the relevant icon appears
just for a while and then it disappears immediately.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the button
8 (if you wish to change the Time Manager
All manuals and user guides at all-guides.com
Type of fabric
For heavy soiled
items
For normal soiled
items
For daily soiled items
For slightly soiled
items
For very slightly
soiled items
For items used or
worn for a short time
For refreshing items
only
For refreshing a very
few items only
option, you must cancel the running pro-
gramme and make your selection again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to and then to the new pro-
gramme position. Start the new programme
by pressing the button 8 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you need
to open it, set first the machine to PAUSE by
pressing the button 8 .
After a few minutes the pilot light 9 goes out
and it is possible to open the door.
If this pilot light remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not try
to force the door!
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to O . After a few mi-
nutes the door can be opened (pay atten-
tion to the water level and tempera-
ture!) .
After closing the door, it is necessary to se-
lect the programme and options again and to
press button 8 .
At the end of the programme
The machine stops automatically. Three
blinking 0.00 appear on the display and the
pilot light of button 8 goes off. Some acoustic
signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the wa-
ter must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O .
to cancel a pro-