Electrolux EWF 127450 W Manual De Instrucciones página 24

24 electrolux
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine
is not impeded by carpets, rugs etc. Check
that the machine does not touch the wall or
other kitchen units. Level the washing ma-
chine by raising or lowering the feet. The feet
may be tight to adjust as they incorporate a
self locking nut, but the machine MUST be
level and stable. If necessary, check the set-
ting with a spirit level. Any necessary adjust-
ment can be made with a spanner. Accurate
levelling prevents vibration, noise and dis-
placement of the machine during operation.
Caution! Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the
floor.
All manuals and user guides at all-guides.com
Water inlet
1. Connect the water inlet hose supplied
Important! Do not use the hose from
your previous machine to connect to the
water supply.
2. The other end of the inlet hose which
3. Set the hose correctly by loosening the
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Warning! This appliance must be
connected to a cold water supply.
with the machine to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.
connects to the machine can be turned
as showed in the picture.
Do not place the inlet hose downwards.
Angle the hose to the left or right depend-
ing on the position of your water tap.
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.