Pioneer DVH-P5000MP Manual De Instrucciones página 5

Connecting the Units
Yellow/black
If you use a cellular telephone, connect it via the
Audio Mute lead on the cellular telephone. If not,
keep the Audio Mute lead free of any
connections.
Connection method
Note
• The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of the
parking brake switch.
Blue/white (7*)
To Auto-antenna relay control terminal
(max. 300 mA 12 V DC).
Blue/white (6*)
Speaker leads
: Front left +
White
: Front left ≠
White/black
: Front right +
Gray
: Front right ≠
Gray/black
: Rear left + or Subwoofer +
Green
: Rear left ≠ or Subwoofer ≠
Green/black
: Rear right + or Subwoofer +
Violet
: Rear right ≠ or Subwoofer ≠
Violet/black
1. Clamp the lead.
Power supply side
Ground side
The pin position of the ISO connector will differ
depending on the type of vehicle. Connect 6*
and 7* when Pin 5 is an antenna control type.
In another type of vehicle, never connect 6*
and 7*.
Blue/white
To system control terminal of the power amp
(max. 300 mA 12 V DC).
When you connect separately sold
multi-channnel processor (DEQ-P7000)
to this unit, do not connect anything to the
speaker leads and system remote control
(blue/white).
2. Clamp firmly with
needle-nosed
pliers.
Parking brake
switch
En 5