Connecting To Separately Sold Power Amp - Pioneer DVH-P5000MP Manual De Instrucciones

Connecting the Units

Connecting to separately sold power amp

Rear audio output
(Refer to pages 8 – 11.)
Antenna jack
(Refer to page 4.)
The pin position of the ISO connector will differ
depending on the type of vehicle. Connect 6*
and 7* when Pin 5 is an antenna control type.
In another type of vehicle, never connect 6*
and 7*.
When you connect separately sold
multi-channnel processor (DEQ-P7000)
to this unit, do not connect anything to the
speaker leads and system remote control
(blue/white).
6 En
IP-BUS input (Blue)
(Refer to page 4.)
Blue/white (6*)
15 cm
Front output
(FRONT OUTPUT)
15 cm
Subwoofer output
or non fading Output
(SUBWOOFER OUTPUT or
NON-FADING OUTPUT)
Optical input
This product
System remote control
Blue/white (7*)
To Auto-antenna relay control terminal
(max. 300 mA 12 V DC).
Note
Change the initial setting of this product
(refer to the Operation Manual).
The subwoofer output of this unit is monaural.
Note
When you connect DEQ-P7000 to this unit,
separately sold power amp must be connected
to DEQ-P7000.