Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the appliance
First, unpack the package ,please install follow the diagram.
•
Install the heating elements ,make sure the safety switch be buckled at the edge of the base.
•
Install wind shield, insert into base as per diagram.
•
Install the grill rack above heating elements.
•
Put 4 foot under the base one by one and turn
•
Do not use the appliance when there is no water in the base plate, keep the water level between
MIN & MAX.
Balcony mounting
Place the two mountings on the balcony balustrade and connect them to the cross strut.
•
Loosen the lockongs and push the rear counterpart on each mounting firmly against the balcony
•
balustrade. Tighten the locking screws again,
Turn the distancer to a horizontal position for solid masonry or concrete balustrades. Use the
•
locking screw on the cross strut to screw the distancer against the balustrade until both brackets
are horizontal or are slightly inclined towards the balustrade.
Turn the distancer to a horizontal position fo frame structures or rail balustrades. Turn the locking
•
screw anticlockwise to clamp the frame post or bar between the cross strut and the distancer
Check that the mounting are secure before attaching the gill.
•
Lift the securing levers on the retaining pins on the brackets. Position the grill pan on the two
•
brackets so that the retaining pins pass through the relevant holes in the rim of the grill pan.
Lower the securing levers again.
Assembing the barbecue grill as described in the section ' installing the appliance'.
•
Thread the safety cable through the hole in the back left rim of the grill pan and the hole above
•
this in the wind unit. Pass the safty cable to a suitable point on the balustrade or side wall of the
balcony.
How to use
The appliance shall be covered with aluminium reflector or similar materials, otherwise it may cause
the danger of overheat.
Power on and adjust it to the expected temperature by the knob of thermostat. The user can adjust it
by turning "MIN/MAX" clockwise.
The appliance will automatically heat to the setting temperature and automatically stop when
reaching the temperature. During the course of heating, the control indicator will light. When
reaching the setting temperature, the control indicator turns off. Once the temperature of the
appliance is lower than the setting temperature, the thermostat automatically heats, and the control
indicator lights, thus assuring heating under constant temperature.
The power consuming level depends on the user's selection. It is suggested to adjust it to highest in
case of long baking. Please adjust the thermostat to "MIN" position for terminating or stopping
baking, then the appliance will be turned off.
Please pull out the appliance from the socket after stopping baking.
V10-01
anti-clockwise.
9
Publicidad
