Disposing Of The Battery - Telwin Start Plus 6824 Manual De Instrucciones

WARNING: DANGER!
this means "REVERSE POLARITY, DANGER!" Never
under any circumstances connect the mounting
socket (Fig. A-1) to the starter 12V or 24V supply and
remove the cables! Make sure the vehicle battery and
starter battery polarities are correct before making
the connections described above.
-. If.there.is.no.acoustic.warning.signal.and.the.red.light.is.
OFF,.place.the.mounting.socket.(Fig..A-1).to.the.starter.
12V.or.24V.supply,.according.to.the.voltage.required.by.
the.vehicle.to.be.started.
-. Turn.the.ignition.switch.(or.key).of.the.vehicle.or.boat.
to. ON,. wait. for. one. minute.. Turn. the. vehicle. ignition.
switch.or.key.to.the.start.position.for.no.more.than.5÷6.
seconds.. If. the. vehicle. or. boat. does. not. start,. wait. at.
least.3.minutes.before.trying.again.
. Warning: Do not allow the black and red
clamps to come into contact with each
other or to touch a common conductor.
-. After.a.successful.start,.with.the.engine.running,.follow.
the. whole. sequence. of. instructions. below. with. great.
care:
1..Disconnect. the. mounting. socket. from. the. starter.
(starter.OFF).
2..Disconnect. the. black. (negative). clamp. from. the.
vehicle.
3..Disconnect.the.red.(positive).clamp.from.the.vehicle.
4..Return.the.clamps.to.their.housing.
. It is highly recommended to recharge the starter as
soon as possible!
Using the starter as a 12 V power supply unit by
means of the cigar-lighter type socket (Fig. A-8).
WARNING! 12V OUTPUT ONLY!
In case of overload the re-settable safety
switch will trip. To restore operation, remove
the cause of overload and press the button shown
in Fig.A-7.
-. Take. the. cover. off. the. cigar-lighter. type. socket. (Fig..
A-8).
-. Insert.the.cigar-lighter.plug.of.the.device.to.be.powered.
into.the.socket.(Fig..A-8).
RECHARGING USING A 230V AC POWER SUPPLY
Important!. To protect the battery and lengthen its
working life, charge it for 12 hours before using it for
the first time, then after every time it is used and, in
any case, at least every 3 months.
-. It. is. possible. to. recharge. the. unit. using. the. 230V.AC.
power. adapter. supplied.. We. recommend. keeping. the.
batteries.fully.charged.at.all.times..A.low.charge.level.
could.shorten.the.life.of.the.battery..Bear.in.mind.that.
the. time. needed. to. recharge. the. battery. depends. on.
the.number.of.times.it.has.been.used.
-. It. is. possible. to. check. the. battery. charge. level. by.
pressing.the."TEST".button.(Fig. A-5): the.display.(Fig.
A-3).indicates.the.battery.voltage,.the.LEDs.(Fig. A-4).
indicate.the.charge.level.
-. The. charging. system. is. electronically. controlled;. the.
factory.setting.for.the.electronics.board.is.suitable.for.
recharging.AGM. lead. type. batteries. contained. by. the.
starter.
-. The. starter. also. foresees. the. use. of. WET. type. free.
electrolyte.lead.batteries..Use.the.optional.Kit.
. The.factory.default.settings.can.be.changed.as.follows:.
with.the.display.switched.off,.press.and.hold.the."TEST".
The symbols shown here
warn that if the red light
comes on (Fig. A-2) and
the buzzer is triggered,
button.(Fig..A-5).and.release.it.only.when.the.display.
(Fig..A-3). indicates.
the. button. once. to. display.
confirm.the.selection.by.holding.the.button.down.until.
the. buzzer. sounds.. To. return. to. the. factory. settings,.
repeat.the.operation.and.select.
Recharging:
WARNING: Use the supplied power supply
adapter only and exclusively to charge the
starter.
-. To.start.with,.insert.the.power.supply.adaptor.plug.(Fig.
B-1).into.a.230V.AC.socket.
-. Then.insert.the.relative.output.plug.(Fig. B-2).into.the.
charger.socket.(Fig. A-6).
-. The. LEDs. (Fig.. A-4). will. light. up. in. succession. to.
indicate.that.the.unit.is.being.charged.
. The.battery.voltages.are.shown.on.the.display.during.
the.recharging.phase.(Fig. A-3)..
-. The.charging.process.is.complete.when.
on.the.display.(Fig. A-3)..Now.unplug.the.charger.and.
disconnect.the.power.supply.adaptor.from.the.mains..
N.B.:
The. starter. has. a. device. for. monitoring. the. charge.
status. of. the. batteries,. therefore. the. power. supply. can.
be. connected. for. as. long. as. desired;. when. charging. is.
complete. it. is. reset. automatically,. depending. on. the.
charge.status.of.the.batteries.
Pb
DISPOSING OF THE BATTERY
When.the.starter.battery.is.completely.run.down.it.should.
be.taken.to.a.re-cycling.depot..In.some.countries.this.is.
mandatory..Contact.the.local.special.refuse.authority.for.
information.on.recycling.
WARNING:. Do. not. burn. the. battery. to. dispose. of. it;.
this. could. cause. an. explosion.. Before. disposing. of. the.
battery,. insulate. the. bare. terminals. to. prevent. shorting..
Do. not. expose. the. battery. to. intense. heat. or. fire:. this.
could.cause.an.explosion.
STARTER SPECIFICATIONS
Type of battery:
-. rechargeable. factory-sealed. (AGM). 12V. acid-lead.
batteries.
Battery capacity:
-. 65Ah.
Output current @ 24V:
-. 3000A.peak.current;
-. 1000A.starter.current;
Output current @ 12V:
-. 6000A.peak.current;
-. 2000A.starter.current;
Copper cables:
-. PVC.insulated.25mm
Cable length:
-. 250cm
Output socket:
-. 12V.DC./.max..current.10A;
General features:
-. warning.light.and.buzzer.for.reverse.polarity;
-. re-settable.safety.switch.for.output.overload;
-. automatic.charging.level.switch.and.automatic.reset;
-. cigar-lighter.type.socket,.12VDC.
Weight:
4
. (AGM. batteries),. then. press.
. (WET. batteries). and.
.
.
2
.is.visible.