Installation Steps - LUND RAMPAGE Trail Ram Center Bull Bar Instrucciones De Instalación

Installation Steps

Place the Bull Bar onto the front bumper
1
Install the 5/8" hardware as shown in the diagram below.
3
Congratulations!
You have purchased one of the many quality Rampage branded products offered by Lund Inernational, Inc. We take the
utmost pride on our products and want you to enjoy years of satisfaction from your investment. We have made every
effort to ensure that your products is top quality in terms of fit, durability, finish and ease of installation.
®
Lund International
800-241-7219 • Visit us at lund International.com
© 2015 Lund International, Inc. All rights reserved.
®
®
Lund and the logo Lund are trademarks of Lund International, Inc.
Page 2 of 2
Use a center punch to mark drill locations and begin drilling
the four holes in the bumper. It will be faster and easier to
begin with a small diameter bit and work your way up to a
5/8" drill bit for the final diameter.
2
Once all hardware is installed, tighten evenly to complete
installation.
4