Operation; Fully Arming The System ("Fully Arm" Mode); Remote Control; Holiday Arming The System ("Holiday Arm" Mode) - Honeywell FRIEDLAND FGGK Serie Manual De Instrucciones

7

Operation

When leaving the premises, the system must be armed. Before arming the system, make sure that all doors and windows are
locked and that the available PIR movement detectors are not obstructed. Make sure that animals are restricted to areas not
protected by PIR movement detectors.
The system has four arming modes: "Fully Arm", "Holiday Arm", "Part Arm-I" and "Part Arm-II".
The "Holiday Arm" mode is a duplicate of the "Fully Arm" mode. The "Fully Arm" mode is commonly used daily, whereas the
"Holiday Arm" mode is used when away on holiday for a longer period. For the "Holiday Arm" mode particularly, you can set up
schedules or events to operate any home automation control receiver to simulate the presence of occupants. For details on
setting up schedules or events, refer to the software manual.
"Part Arm-I" and "Part Arm-II" allow for selected detectors or zones to be disarmed while other detectors or zones are armed.
When the system is armed, the display shows the arming mode and the programmed exit delay counting down. If the exit delay
beeps are enabled, the control panel will emit beeps with the beep rate increasing in steps as the exit delay expires. At the end
of the exit period, all active zones are fully armed. The user must have left the premises and closed the final protected door.
When the system is armed and a detector on an active zone is triggered, the display shows the programmed entry delay for the
zone counting down. If the entry delay beeps are enabled, the control panel will emit beeps with the beep rate increasing in
steps as the entry delay expires. If the system has not been disarmed when the entry delay expires, a full alarm will occur.
Details of the zone event that triggered the alarm are recorded in the event log.
At the end of the alarm time, the alarms will stop and the system will re-arm itself automatically (subject to the conditions of
the zone lockout feature).
7.1

Fully arming the system ("Fully Arm" mode)

Remote control

1. Press the button once.
7.2

Holiday arming the system ("Holiday Arm" mode)

Remote control
1. Press the button twice.
Control panel
1. Press the button once.
2. Enter the 4-digit PIN code (User).
3. Press the button.
Control panel
1. Press the button twice.
2. Enter the 4-digit PIN code (User).
3. Press the button.
24