Home Automation Control Setup (Receiver-Type Of Devices) (Home Auto. Control Setup); Learning The Receiver (Link Panel To Control); Switching On And Off All Receivers (All On); Remote Access (Remote Access) - Honeywell FRIEDLAND FGGK Serie Manual De Instrucciones

6.2.4.1

Home automation control setup (receiver-type of devices) (HOME AUTO. CONTROL SETUP)

The feature concerns the use of receiver-type of devices only.
6.2.4.1.1

Learning the receiver (LINK PANEL TO CONTROL)

The control panel can learn up to 32 home automation control receivers.

Press and hold the learn button on the receiver for 3 seconds. The learn indicator flashes quickly. The learn indicator on
the receiver stops flashing when the ID code of the control panel is confirmed.
Message
SENDING ID CODE WAIT 2S
WAIT 2 SECOND TEST
6.2.4.1.2

Switching on and off all receivers (ALL ON)

You can switch on and off all home automation control receivers of the group.
6.2.4.1.3

Remote access (REMOTE ACCESS)

You can enable and disable remote access to and control of the home automation control receivers.
Example: If the home automation control receiver is connected to a coffee maker and the remote access is set to "ON", the
coffee maker will switch to "ON" through the online GlobalGuard software or through the GlobalGuard app.
Note: If the appliance connected to the home automation control receiver requires your attention during operation, set the
remote access to "OFF".
6.2.4.1.4

Model type (MODEL TYPE)

You can set the model type for the home automation control.
6.2.4.1.5

Home automation control status (CONT. STATUS)

You can enable or disable operation of the home automation control receiver.
6.2.4.1.6

Deleting the home automation control (CONT. REMOVE)

You can delete the settings of the home automation control receiver from the control panel.
6.2.4.2

Home automation control setup (transmitter-type of devices) (HOME AUTO. REMOTE/SENSOR)

The feature concerns the use of transmitter-type of devices only.
6.2.4.2.1

Learning the transmitter (LEARNING ID)

The control panel can learn up to 32 home automation control transmitters.

Press and hold the learn button on the transmitter for 3 seconds.
Message
LEARNING OK
TIME OUT
ID DUPLICATE
6.2.4.2.2

Device status (DEVICE STATUS)

You can enable or disable operation of the home automation control transmitter.
6.2.4.2.3

Deleting the device (DEVICE REMOVE)

You can delete the settings of the home automation control transmitter from the control panel.
The ID code was emitted from the control panel.
The ID code was learned by the receiver. The receiver switches on and off once
The ID code was learned by the control panel successfully.
If you do not press the learn button on the transmitter within 30 seconds,
The same ID code was learned by the control panel beforehand.
22
Meaning
automatically.
Meaning
a time-out will occur.