geberit Rapid Manual Del Usuario página 44

EN
Malfunction
Does not flush.
Water runs
continuously.
Flush time
cannot be set
to a lower
value
(maximum
flush time of
15 minutes is
set).
1)
Flush actuations will no longer take place if the battery is almost dead.
Skilled persons will find further information on
troubleshooting in the maintenance manual
967.987.00.0 on the website of the respective Geberit
sales company or via the adjacent QR code.
44
Cause
Solenoid valve or
control unit
defective
Battery dead
Pipe pressure too
low
Basket filter
clogged
Solenoid valve or
control unit
defective
Software error
Rectification
▶
Contact a skilled person.
▶
Replace the battery. →
See "Replacing the
battery", page 46.
▶
Contact a skilled person.
▶
Contact a skilled person.
▶
Close the water tap.
▶
Contact a skilled person.
▶
Reset control unit by
disconnecting the battery
cable and plugging it
back in.
18014401053566091-1 © 07-2018
967.986.00.0 (01)